Phone: 701-277-1022 Toll Free: 1-877-915-8790 Fax: 701-277-0945

Tree Shear

Tree Shears


  • Single blade eliminates center cut splinters that double blade designs leave behind.
  • Blade moves from left to right for better operator visibility.
  • Half the wear on parts compared to double blade design.
  • Concave jaw design provides a natural gripping action on tree.
  • Able to cut trees at ground level and rotate to cut tree limbs.
  • 3” x 8” hydraulic tilt cylinder rotates cutter head 110 degrees.
  • Massive three inch blade pivot pin provides unmatched rotational strength.
  • All pivot points are greaseable for extended life.
  • T-1 steel cutting edge – three times tougher than typical steel. Jaws and body of shear are made of high strength steel.
  • The Treerex can cut trees up to 16” in diameter in a single cycle.
  • The Treerex chassis is made of CHT-400 steel.
  • The Treerex’s ability to rotate lets you move fallen trees.
  • The single electro-hydraulic valve activates both hydraulic cylinders.


  • Six inch hydraulic cylinder renders 85,000 lbs of pressure at 3000 psi.
  • The two blades are driven by a single cylinder, which allows for faster cutting.
  • Its length (67 in.) gives it an unprecedented reach.
  • Its height (9 in.) and width (21 in.) allow it to get into tight areas.
  • The tree shear is equipped with a 2 ½ in. hydraulic cylinder that allows it to pivot 90 degrees.
  • Cuts trees up to 8 inches in diameter.
  • All articulations are greaseable, so as to extend life expectancy of your tree shear.
  • The blades are made of durable RT-400 steel, 4 times more durable than ordinary steel.
  • Fits all agricultural and commercial loaders.
  • The electromagnetic valve lets the tree shear perform two hydraulic functions with one command.
  • Weight 850 lbs. (385kg).


  • Six inch hydraulic cylinder renders 85,000 lbs of pressure at 3000 psi.
  • The cylinder’s thrust provides each blade with 66,500 psi
  • All pivot points are greasable for extended life
  • The blade structural support ares are equipped with MOS-2 polyethylene bushings
  • A shield provides increased protection for the hydraulic hoses
  • Three inch pins
  • Adjustable blades that can be sharpened
  • Hydraulic pressure: min. of 2,200 psi, max. of 5,000 psi
  • Minimum flow of 10 Gals per minute